Payment & Shipping Terms:
|Material:||Cement, Quartz Sand, Fiber||Density:||1.4g/cm3|
|Packaging Details:||Standard Wooden Pallets + Corner Protector + Cover||Radioactivity:||Decorative Materials Class A|
|Fire Resistance:||4 Hours||Advantage:||Waterproof Material, Fast Install|
SINOMA Fiber cement board is a stable performance and light weight building &decoration board used cement as major and natural reinforced, with the process of pulping,emulsion,forming,pressurization,autoclaving,drying and surface treatment.
Thickness : 4.5mm-30mm
Size :1200*2400mm, 1220*2440mm, 1220*3000mm,1200*3000mm
Surface : 40#-120# sanding surface , polished surface , tapered edge .
Product characteristics :
Density : 1.2-1.5G/CM3
Fire-proof Rate : A-Class incombustible (GB8624-1997)
Incombustibility(min): 240 minutes (GB/T9978-1999)
Water content : ≤30%
Swelling ratio: ≤0.4%
Anti-bending Strength: ≥16MPA
Frost resistance : Don’t appear cracking and delamination after 25 cycles of freezing and thawing . (GB/T7019-1997)
Radioactivity: standard of GB6566-2001 (A-class Decoration Materials)
Partition board , exterior wall cladding , panel, suspended ceilings ,light
weight grouting panel, interior dry wall decoration board ,interior wall
after painting and coating .
The largest manufacturer in North China
The largest pressing machine in China manufacturer ---9000 tons
20 years production time, 15 years export experience
China most famous project--- Bird Nest supplier
The drafter and expurgator of China Industrial Standard
Passed ASTMC 1186 test standard
Assessed by CE authentication
High temperature, high pressure autoclaved for 24 hours
High strength with 9000 tons pressing machine
Excellent fire-proof performance, A1class incombustible
Excellent water-proof, damp-proof performance
Excellent heat and sound insulation
Durability and long service life
Easy processing and installation, save cost and time
Green Building Material Certificate
National Research Center Test Report
No special tools are required. The products can be used with normal nails, fastened by normal or self-drilling screws and cut by an electric power saw with a diamond blade.
Sinoma Board can be fixed to both timber (minimum size 1.5 x 3 inches) or steel frames (at least 0.55 mm thickness). The board must be supported at the edge at intermediate positions with centers not exceeding 600 mm. Screws must be located more than 12 mm from edges and 50 mm from board corners.
Fasteners can be both nails and screws. It can be nailed directly to timber supports with round wire nails. For metal screws, the size and length of the screw depends on the thickness of the board and the gauge of framing.
Since fiber-cement board is subject to slight dimensional changes, a butt joint can be used in dry partitioning areas or where an exposed joint appearance is acceptable. For better water protection, either flexible acrylic or polyurethane based sealant can be used to seal gaps of 3-5mm.
Transportation, Handing and Storage:
Deliver SINOMA Board to the project site in the original, unopened package and store them in fully enclosed space where they will be protected against damage from humidity, direct sunlight, surface contamination and other causes of damage. Handle SINOMA Board carefully to avoid chipping the edges or damaging units in any way. Handling and storage practices should follow the manufacturer’s recommended suggestions at all times.